|
|
|
|
|
|
It is currently Fri May 24, 2013 6:19 pm
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 6 posts ] |
|
| Author |
Message |
|
Ballydoolagh
KG Newbie
Joined: Thu May 12, 2011 11:36 pm Posts: 13 Location: Fermanagh
|
 Questions on raised beds
Not sure if this is in the right section or not but I have a couple of questions on raised beds. I wanted to make beds to better divide a field I have. The beds are more to show the boundaries of where I am planting rather than to raise the soil. I had thought of using something like 6x2 pressure treated timber, having them 1 board high and putting them into the ground about an inch. Then I was going to get polythene and staple it to the inside. My field is on a slope (gentle but sloped non the less). I was going to have the beds sloped rather than level them up. Can anyone advise if I am on the correct lines? I'm looking to make about 10 at 4x10 foot sizes so don't want to start off wrong. Thanks
|
| Thu Oct 13, 2011 9:45 pm |
|
 |
|
MikA
KG Regular
Joined: Wed Apr 13, 2011 11:35 am Posts: 186 Location: Gloucestershire - Cotswold Edge
|
 Re: Questions on raised beds
Don't know much about raised beds in large plots but I would be a bit worried by the thought of the polythene liner. If you had a really heavy spell of rain you may end up with muddy ponds instead of good soil. If you want to prevent weeds coming through use a weed suppressant membrane instead.
MikA
|
| Thu Oct 13, 2011 10:49 pm |
|
 |
|
Johnboy
KG Regular
Joined: Tue Nov 22, 2005 2:15 pm Posts: 5405 Location: NW Herefordshire
|
 Re: Questions on raised beds
Hi Ballydoolagh, My beds are what are termed as 'designated beds' that are simply beds with the edges defined with 4 x 1 inch treated timber. My beds vary in width some 4ft some 6ft but all are 33ft long. My Paths are all 30 inches wide. I do not quite understand the polythene bit. Perhaps if you could explain that a little I might understand. JB.
|
| Fri Oct 14, 2011 4:52 am |
|
 |
|
Ballydoolagh
KG Newbie
Joined: Thu May 12, 2011 11:36 pm Posts: 13 Location: Fermanagh
|
 Re: Questions on raised beds
The polythene was to staple to the wood to help prevent it from rotting quicker. It would only be around the perimiter and not on the bottom of the bed. Is this much benefit or will the wood last just as long without? How often do you have to replace yours? If I was able to make them and add fresh(ish) manure, would it be ok to plant in the spring. Lots of farmers around me but no well rotted stuff.
|
| Sat Oct 15, 2011 3:05 pm |
|
 |
|
FelixLeiter
KG Regular
Joined: Tue Apr 28, 2009 12:18 pm Posts: 596 Location: East Yorkshire
|
 Re: Questions on raised beds
Since you're using pressure-treated timber, you don't need to give it any protection. If anything, the polythene could only serve to retain moisture around the wood, which isn't really what you want. If the only manure you can get is long, dig it in now and it should be about right by the time spring comes.
_________________ Allotment, but little achieved.
|
| Sat Oct 15, 2011 8:15 pm |
|
 |
|
glallotments
KG Regular
Joined: Sat Dec 01, 2007 5:27 pm Posts: 2074 Location: West Yorkshire
|
 Re: Questions on raised beds
Ballydoolagh wrote: The polythene was to staple to the wood to help prevent it from rotting quicker. It would only be around the perimiter and not on the bottom of the bed. Is this much benefit or will the wood last just as long without? How often do you have to replace yours? If I was able to make them and add fresh(ish) manure, would it be ok to plant in the spring. Lots of farmers around me but no well rotted stuff. Make sure you check your manure source carefully http://www.kitchengarden.co.uk/forum/viewtopic.php?f=9&t=7863
_________________ visit my website http://ossettweather.com/glallotments.co.uk/index.html blog http://glallotments.blogspot.com and school gardening website http://theschoolvegetablepatch.co.uk/index.html Weather blog http://ossettweather.blogspot.com/
|
| Sun Oct 16, 2011 10:40 am |
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|